DTC P1616 Communication Error from ECM to Distance Control ECU |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1616 | While the dynamic laser cruise control is either preparing for operation or operating, if the ECM continuously receives a logical error signal from the distance control ECU for 0.15 seconds, the ECM records this logical error code |
|
| 1.REPLACE ECM |
Replace the ECM.
| NEXT | |
| 2.PERFORM INITIALIZATION |
Perform initialization (Click here).
Turn the ignition switch to ON.
Turn the cruise control main switch on.
With the brake pedal depressed, push the cruise control main switch to + (ACCEL)/RES (RESUME) 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.
| NEXT | |
| 3.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 4.CHECK FOR DTC |
Reproduce the DTC detection conditions under which the DTC is stored.
Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||