Home › Engine / Hybrid System ยท CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    P1617    Distance Control ECU Malfunction

for Preparation Click here


DESCRIPTION

In the dynamic laser cruise control system, the ECM and the distance control ECU communicate with one another to control the system based on certain designation information. If the designation information of the ECM and distance control ECU are different or the distance control ECU is malfunctioning, this DTC is recorded.

DTC No.
DTC Detection Condition
Trouble Area
P1617
While the dynamic laser cruise control is either preparing for operation or operating, if a designation signal from the ECM and a designation return signal from the distance control ECU do not match or the distance control ECU is malfunctioning for 0.3 seconds, the ECM records this trouble code
Distance control ECU

INSPECTION PROCEDURE

NOTICE:
When the distance control ECU and ECM is replaced with a new one, initialization must be performed (Click here).

1.PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    1. Turn the ignition switch to ON.

    2. Turn the cruise control main switch on.

    3. With the brake pedal depressed, push the cruise control main switch to + (ACCEL)/RES (RESUME) 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.

      OK:
      The skid control buzzer sounds. (Initialization is performed.)

      NOTICE:
      1. Do not turn the light control switch on at this time because the beam axis automatic adjustment mode has already started, which could lead to incorrect beam axis. If the light control switch is turned on by mistake, readjust the beam axis (refer to Beam Axis Adjustment) (Click here).
      2. If initialization cannot be performed, first inspect the stop light switch circuit, cruise main switch circuit, and skid control buzzer circuit.



NG
REPLACE DISTANCE CONTROL ECU (Click here)
OK


2.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


3.CHECK FOR DTC
  1. Reproduce the DTC detection conditions under which the DTC is stored.

    HINT:
    If the DTC detection conditions are not correct, the system will not detect the trouble.

  1. Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.

  1. Check for DTCs (Click here).

    OK:
    P1617 is not output.



NG
Go to step 4
OK

END 

4.REPLACE DISTANCE CONTROL ECU
  1. Replace the distance control ECU (Click here).


NEXT


5.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


6.CHECK FOR DTC
  1. Reproduce the DTC detection conditions under which the DTC is stored.

    HINT:
    If the DTC detection conditions are not correct, the system will not detect the trouble.

  1. Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for 3UR-FE)
    B
    DTC is output (for 3UR-FBE)
    C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A

END (DISTANCE CONTROL ECU IS DEFECTIVE)