Home › Engine / Hybrid System ยท CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0122    Lost Communication with Vehicle Dynamics Control Module

DTC    U0126    Lost Communication with Steering Angle Sensor Module

DTC    U1101    Lost Communication with Distance Control ECU

for Preparation Click here


DESCRIPTION

The ECM communicates several signal with each sensors or ECUs by CAN communication circuit. There are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.

DTC No.
DTC Detection Condition
Trouble Area
U0100
While the dynamic laser cruise control is either preparing for operation or operating, if the ECM continuously receives a communication cut off signal from the distance control ECU for 0.5 seconds, the ECM records this communication cut off code
  1. Communication circuit
  2. ECM
  3. Distance control ECU
While the dynamic laser cruise control is either preparing for operation or operating, if the ECM continuously receives a communication cut off signal from the skid control ECU for 1.0 seconds, the ECM records this communication cut off code
  1. Communication circuit
  2. ECM
  3. Skid control ECU
U0122
While dynamic laser cruise control is either preparing for operation or operating, if communication data from the skid control ECU is invalid for a certain amount of time, the ECM records this communication cut off code
  1. Communication circuit
  2. Skid control ECU
  3. ECM
U0126
While the dynamic laser cruise control is either preparing for operation or operating, if the ECM continuously receives a steering sensor communication error signal for 0.15 seconds, the distance control ECU sends a signal to the ECM to record this trouble code
  1. Communication circuit
  2. Steering angle sensor
  3. Distance control ECU
  4. ECM
U1101
While the dynamic laser cruise control is either preparing for operation or operating, if communication data from the distance control ECU is invalid for 1.08 seconds, the ECM records this communication cut off code
  1. Communication circuit
  2. Distance control ECU
  3. ECM

INSPECTION PROCEDURE

Refer to CAN Communication System (Click here).