Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the navigation system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.BASIC INSPECTION
    1. Turn the ignition switch to ACC.

    2. Check whether or not the display appears on the navigation receiver assembly.
      Result 
      Result
      Proceed to
      Display appears
      A
      Display does not appear
      B



    B.
    Go to step 6
    A


    4.CHECK FOR DTC
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs.

    3. Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the navigation system DTCs by simulating the condition indicated by the DTCs.

      HINT:
      1. Even if the malfunction symptom is not confirmed, check for DTCs as the system stores past DTCs.
      2. Refer to the detailed description on the diagnostic screen as necessary (Click here).
      3. Check and clear past diagnostic trouble codes. Check the diagnostic trouble code and inspect the area the code indicates.

      Result 
      Result
      Proceed to
      DTC output does not reoccur
      A
      DTC output reoccurs
      B



    B.
    Go to step 7
    A


    5.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B



    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).

    2. Inspect the front No. 1 speaker assembly (Click here).

    3. Inspect the front No. 2 speaker assembly (Click here).

    4. Inspect the front No. 3 speaker assembly (Click here).

    5. Inspect the front No. 4 speaker assembly (Click here).

    6. Inspect the rear No. 1 speaker assembly (Click here).

    7. Inspect the rear No. 2 speaker assembly (Click here).

    8. Inspect the quarter side speaker assembly (Click here).

    9. Inspect the w/ Box No. 1 speaker assembly (Click here).


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT

      END