NAVIGATION SYSTEM (for SD) > TERMINALS OF ECU |
| CHECK NAVIGATION RECEIVER ASSEMBLY |

Disconnect the I26 navigation receiver assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| I26-3 (ACC) - I26-7 (GND) | GR - W-B | ACC power supply | Ignition switch off | Below 1 V |
| Ignition switch ACC | 11 to 14 V | |||
| I26-4 (B) - I26-7 (GND) | L - W-B | Battery | Always | 11 to 14 V |
| I26-7 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the I26 navigation receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| I45-1 (PKB) - I26-7 (GND) | R - W-B | Parking brake signal | Ignition switch ON, parking brake switch on | 11 to 14 V |
| Ignition switch ON, parking brake switch off | Below 1 V | |||
| I45-3 (SPD) - I26-7 (GND) | W - W-B | Speed signal from combination meter | Ignition switch ON, drive wheels turned slowly | Pulse generation |
| I45-5 (REV) - I26-7 (GND) | G - W-B | Reverse signal | Ignition switch ON, shift lever in R | 11 to 14 V |
| Ignition switch ON, shift lever not in R | Below 1 V | |||
| I26-1 (FR+) - I26-7 (GND) | LG - W-B | Sound signal (Front right) | Audio system playing | Waveform synchronized with sound is output |
| I26-2 (FL+) - I26-7 (GND) | Y - W-B | Sound signal (Front left) | Audio system playing | Waveform synchronized with sound is output |
| I26-5 (FR-) - I26-7 (GND) | L - W-B | Sound signal (Front right) | Audio system playing | Waveform synchronized with sound is output |
| I26-6 (FL-) - I26-7 (GND) | W - W-B | Sound signal (Front left) | Audio system playing | Waveform synchronized with sound is output |
| I26-10 (ILL+) - I26-7 (GND) | SB - W-B | Illumination signal | Light control switch OFF | Below 1 V |
| Light control switch TAIL or HEAD | 11 to 14 V | |||
| I27-1 (RR+) - I26-7 (GND) | B - W-B | Sound signal (Rear right) | Audio system playing | Waveform synchronized with sound is output |
| I27-2 (RL+) - I26-7 (GND) | R - W-B | Sound signal (Rear left) | Audio system playing | Waveform synchronized with sound is output |
| I27-3 (RR-) - I26-7 (GND) | Y - W-B | Sound signal (Rear right) | Audio system playing | Waveform synchronized with sound is output |
| I27-5 (ILL-) - I26-7 (GND) | BE - W-B | Illumination signal | Light control switch OFF → TAIL or HEAD | Below 1 V → 11 to 14 V |
| I27-6 (RL-) - I26-7 (GND) | W - W-B | Sound signal (Rear left) | Audio system playing | Waveform synchronized with sound is output |
| I28-11 (V+) - I28-12 (V-) | R - Shielded | Television camera image signal | Ignition switch ON, shift lever in R | Pulse generation (refer to waveform 1) |
| Ignition switch ON, shift lever in R, screen blacked out by covering camera lens | Pulse generation (refer to waveform 2) | |||
| I28-12 (V-) - I26-7 (GND) | Shielded - W-B | Shielded ground | Always | Below 1 V |
| I28-13 (CA+) - I26-7 (GND) | B - W-B | Television camera power supply | Ignition switch ON, shift lever in R | 5.5 to 7.05 V |
| I28-14 (CGND) - I26-7 (GND) | W - W-B | Television camera signal ground | Always | Below 1 V |
| I28-6 (SWG) - Body ground | BR - Body ground | Steering pad switch signal | Always | Below 1 V |
| I28-7 (SW1) - I28-6 (SWG) | LG - BR | Steering pad switch signal | No switch pushed | 2.16 to 2.81 V |
| SEEK+ switch pushed | 0.00 to 0.37 V | |||
| SEEK- switch pushed | 0.44 to 0.68 V | |||
| VOL+ switch pushed | 0.98 to 1.38 V | |||
| VOL- switch pushed | 1.57 to 2.09 V | |||
| I28-8 (SW2) - I28-6 (SWG) | GR - BR | Steering pad switch signal | No switch is pushed | 2.16 to 2.81 V |
| MODE switch pushed | 0.00 to 0.37 V | |||
| ON HOOK switch pushed | 0.44 to 0.68 V | |||
| OFF HOOK switch pushed | 0.98 to 1.38 V | |||
| VOICE switch pushed | 1.57 to 2.09 V | |||
| I28-15 (ARI) - I26-7 (GND) | R - W-B | Aux sound signal (right) | External device playing (When stereo jack used) | Waveform synchronized with sound is output |
| I28-16 (ASGN) - I26-7 (GND) | W - W-B | Ground | Always | Below 1 V |
| I28-17 (ALI) - I26-7 (GND) | B - W-B | Aux sound signal (left) | External device playing (When stereo jack used) | Waveform synchronized with sound is output |
| I28-18 (AUXG) - I26-7 (GND) | Shielded - W-B | Shielded ground | Always | Below 1 V |
| I28-19 (AUXI) - I26-7 (GND) | SB - W-B | External device connection detection signal | External device playing (When stereo jack used) | Waveform synchronized with sound is output |
| I49-1 (SNS2) - I26-7 (GND) | LG - W-B | Microphone connection detection signal | Always | Below 1 V |
| I49-2 (MIC+) - I26-7 (GND) | R - W-B | Microphone voice signal | "Bluetooth" handsfree function on | Waveform synchronized with sound is output |
| I49-3 (MACC) - I26-7 (GND) | B - W-B | Telephone microphone assembly power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 4 to 6 V | |||
| I49-5 (MIC-) - Body ground | W - Body ground | Microphone voice signal | "Bluetooth" handsfree function on | Waveform synchronized with sound is output |
| I49-6 (SGND) - I26-7 (GND) | Shielded - W-B | Shielded ground | Always | Below 1 V |
| I50-1 | # | USB power source | - | - |
| I50-2 | # | USB data signal | - | - |
| I50-3 | # | USB data signal | - | - |
| I50-4 | # | USB ground | - | - |
![]() |
Using an oscilloscope, check the waveform.
Waveform 1
| Item | Content |
| Terminal No. (Symbol) | I28-11 (V+) - I28-12 (V-) |
| Tool Setting | 0.2 V/DIV., 50 μs/DIV. |
| Condition | Ignition switch ON, shift lever in R |
Waveform 2
| Item | Content |
| Terminal No. (Symbol) | I28-11 (V+) - I28-12 (V-) |
| Tool Setting | 0.2 V/DIV., 50 μs/DIV. |
| Condition | Ignition switch ON, shift lever in R, screen blacked out by covering camera lens |
| *a | Waveform 1 |
| *b | Waveform 2 |
| *c | Synchronized Signal |
| *d | Video Waveform |