Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Parking Brake Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit is from the parking brake switch to the navigation receiver assembly.

WIRING DIAGRAM


E190584E02


INSPECTION PROCEDURE

1.CHECK PARKING BRAKE SWITCH ASSEMBLY (DISPLAY CHECK MODE)


    I038223E16
  1. Enter the "Display Check" mode and select "Vehicle Signal Check" (Click here).

  1. Check that the display changes between ON and OFF according to the parking brake operation.

    OK:
    Parking Brake Position
    Display
    Applied
    ON
    Released
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - PARKING BRAKE SWITCH)


    E191662E03
  1. Disconnect the I6 navigation receiver assembly connector.

  1. Disconnect the A5 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I6-1 (PKB) - A5-1
    Always
    Below 1 Ω
    I6-1 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY


    C159029E02
  1. Remove the parking brake switch assembly connector (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Parking brake switch ON (Switch pin released)
    Below 1 Ω
    Parking brake switch OFF (Switch pin pushed in)
    10 kΩ or higher



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR