NAVIGATION SYSTEM (for SD) > Steering Pad Switch Circuit |

| 1.INSPECT STEERING PAD SWITCH ASSEMBLY |
Remove the steering pad switch assembly (Click here).

| *1 | Volume+ Switch | *2 | Volume- Switch |
| *3 | Seek+ Switch | *4 | Seek- Switch |
| *5 | On Hook Switch | *6 | Off Hook Switch |
| *7 | MODE Switch | *8 | Voice Switch |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| z12-10 (AU1) - z12-8 (EAU) | No switch is pushed | 95 to 105 kΩ |
| Seek+ switch is pushed | Below 2.5 Ω | |
| Seek- switch is pushed | 313 to 345 Ω | |
| Volume+ switch is pushed | 950 to 1050 Ω | |
| Volume- switch is pushed | 2955 to 3265 Ω | |
| z12-9 (AU2) - z12-8 (EAU) | No switch is pushed | 95 to 105 kΩ |
| MODE switch is pushed | Below 2.5 Ω | |
| On hook switch is pushed | 313 to 345 Ω | |
| Off hook switch is pushed | 950 to 1050 Ω | |
| Voice switch is pushed | 2955 to 3265 Ω |
|
| ||||
| OK | |
| 2.INSPECT SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Remove the spiral cable sub-assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 8 (EAU) - 4 (EAU) | Spiral cable is turned 2.5 rotations counterclockwise | Below 1 Ω |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise | ||
| 10 (AU1) - 6 (AU1) | Spiral cable is turned 2.5 rotations counterclockwise | |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise | ||
| 9 (AU2) - 5 (AU2) | Spiral cable is turned 2.5 rotations counterclockwise | |
| Spiral cable is centered | ||
| Spiral cable is turned 2.5 rotations clockwise |
| *a | Steering Pad Switch Side |
| *b | Vehicle Side |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY) |
Disconnect the I28 navigation receiver assembly connector.
Disconnect the H54 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I28-7 (SW1) - H54-6 (AU1) | Always | Below 1 Ω |
| I28-8 (SW2) - H54-5 (AU2) | Always | Below 1 Ω |
| I28-6 (SWG) - H54-4 (EAU) | Always | Below 1 Ω |
| I28-7 (SW1) - Body ground | Always | 10 kΩ or higher |
| I28-8 (SW2) - Body ground | Always | 10 kΩ or higher |
| I28-6 (SWG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||