Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM


E190361E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BATTERY AND BODY GROUND)


    B130117E25
  1. for 8 Speakers

    1. Disconnect the I1 radio receiver assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      I1-7 (GND) - Body ground
      Always
      Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      I1-4 (B) - Body ground
      Always
      11 to 14 V
      I1-3 (ACC) - Body ground
      Ignition switch ACC
      11 to 14 V



    E190398E01
  1. for 14 Speakers

    1. Disconnect the I4 radio receiver assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      I4-20 (GND) - Body ground
      Always
      Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      I4-1 (B) - Body ground
      Always
      11 to 14 V
      I4-11 (ACC) - Body ground
      Ignition switch ACC
      11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)