DTC P0722 Output Speed Sensor Circuit No Signal |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0722 | All conditions below are detected 5 seconds or more continuously (2-trip detection logic) (a) No signal from speed sensor SP2 is input to ECM while 4 pulses of No. 1 vehicle speed sensor signal are sent (b) Vehicle speed is 9 km/h (5.59 mph) or more (c) Park/neutral position switch is OFF |
|

| Item | Content |
| Terminal No. (Symbol) | D56-101 (SP2+) - D56-100 (SP2-) |
| Tool setting | 2 V/DIV., 20 msec./DIV |
| Condition | Vehicle speed 20 km/h (12 mph) |
| Related DTCs | P0722: Speed sensor SP2/Verify pulse input |
| Required Sensors/Components | Speed sensor (SP2) |
| Frequency of operation | Continuous |
| Duration | 5 seconds |
| MIL operation | 2 driving cycles |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | None |
| Vehicle speed at vehicle speed sensor | 9 km/h (5.59 mph) or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Speed sensor signal | No signal |
| Vehicle speed at output speed sensor | 9 km/h (5.59 mph) or more |

| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| SPD (SP2) | Output shaft speed/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) | Vehicle stopped: 0 km/h (0 mph) (output shaft speed is equal to vehicle speed) | - |
| 1.INSPECT SPEED SENSOR SP2 INSTALLATION |
![]() |
Check the speed sensor SP2 installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR SP2 |
![]() |
Disconnect the D44 speed sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR SP2 - ECM) |
![]() |
Disconnect the D56 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D56-101 (SP2+) - D56-100 (SP2-) | 20°C (68°F) | 560 to 680 Ω |
| D56-101 (SP2+) - Body ground | Always | 10 kΩ or higher |
| D56-100 (SP2-) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
| NG | A |
| OK (for 3UR-FE) | B |
| OK (for 3UR-FBE) | C |
|
| ||||
|
| ||||
| A | ||
| ||