Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY

FRONT DRIVE SHAFT ASSEMBLY > REMOVAL

for Preparation Click here



1. DRAIN FRONT DIFFERENTIAL OIL
  1. Stop the vehicle on a level place.

  1. for Front Differential:

    1. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    2. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    3. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      39 N*m{ 400 kgf*cm , 29 ft.*lbf }

  1. for Rear Differential:

    1. Using a 10 mm hexagon wrench, remove the filler plug and gasket.

    2. Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.

    3. Using a 10 mm hexagon wrench, install a new gasket and the drain plug.

      Torque:
      65 N*m{ 660 kgf*cm , 48 ft.*lbf }



2. REMOVE STEERING KNUCKLE ASSEMBLY
  1. Remove the steering knuckle assembly (Click here).



3. REMOVE FRONT DRIVE SHAFT ASSEMBLY


    C171948
  1. Using SST, remove the front drive shaft assembly.

    SST
    09520-24010   (09520-32040)
    09520-01010  

    NOTICE:
    Be careful not to damage the differential oil seal, inboard joint boot and drive shaft dust cover.