REAR DRIVE SHAFT ASSEMBLY > REMOVAL |
| 1. DRAIN REAR DIFFERENTIAL OIL |
Stop the vehicle on a level place.
for Front Differential:
Using a 10 mm hexagon wrench, remove the filler plug and gasket.
Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.
Using a 10 mm hexagon wrench, install a new gasket and the drain plug.
for Rear Differential:
Using a 10 mm hexagon wrench, remove the filler plug and gasket.
Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.
Using a 10 mm hexagon wrench, install a new gasket and the drain plug.
| 2. REMOVE REAR AXLE CARRIER ASSEMBLY |
Remove the rear axle carrier assembly (Click here).
| 3. REMOVE REAR DRIVE SHAFT ASSEMBLY |
![]() |
Using SST, remove the rear drive shaft assembly.