COMPRESSOR > REMOVAL |
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
Switch A/C ON.
Turn the blower switch to ON.
Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.
Stop the engine.
![]() |
Remove the caps from the service valves on the refrigerant line.
Connect the refrigerant recovery unit.
Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.
| 2. REMOVE FAN & GENERATOR V BELT |
Remove the fan and generator V belt (Click here).
| 3. REMOVE FENDER APRON MUDGUARD SEAL LH |
![]() |
Remove the 6 clips and seal.
| 4. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE |
![]() |
Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.
Remove the O-ring from the cooler refrigerant suction hose.
| 5. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() |
Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.
Remove the O-ring from the cooler refrigerant discharge hose.
| 6. REMOVE COOLER COMPRESSOR ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 2 bolts and 2 nuts.
Remove the 2 stud bolts and cooler compressor.