Home › Power Source / Network ยท 3UR-FE BATTERY / CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY


A187035E01
SST
09820-63011   (09820-06010, 09820-06021)

HINT:
SST 1-A and B
09820-06010
SST 2
09820-06021

  1. Clamp the generator housing stay in a vise.

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured on the rotor shaft.



    A187036E01
  1. Insert SST 2, and attach the pulley nut to SST 2.



    A187037E01
  1. To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.

  1. Remove the generator from SST 2.



    A187038E01
  1. Turn SST 1-B, and remove SST 1-A and B.

  1. Remove the pulley nut and pulley.



2. REMOVE GENERATOR REAR END COVER


    A163586
  1. Place the generator on the pulley.

  1. Remove the 3 nuts and end cover.



    A156408
  1. Remove the terminal insulator.



3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A156409
  1. Remove the 2 screws and brush holder.



4. REMOVE GENERATOR COIL ASSEMBLY


    A156414
  1. Remove the 4 bolts.



    A156415E01
  1. Using SST, remove the coil assembly.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)

  1. Remove the generator washer.



5. REMOVE GENERATOR ROTOR ASSEMBLY