TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU |
| CHECK TIRE PRESSURE WARNING ECU |

Disconnect the O14 tire pressure warning antenna and receiver connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| H40-12 (RDA) - H40-9 (GND) | G - W-B | Tire pressure warning antenna and receiver signal | Ignition switch ON | 11 to 14 V |
Connect the O14 tire pressure warning antenna and receiver connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| H40-1 (CLSW) - H40-9 (GND) | B - W-B | Tire pressure warning reset switch | Ignition switch ON Tire pressure warning reset switch OFF | 8 to 14 V |
| Ignition switch ON Tire pressure warning reset switch ON | Below 1.5 V | |||
| H40-2 (SPD) - H40-9 (GND) | V - W-B | Vehicle speed signal | Vehicle is running | Pulse generation (see waveform 1) |
| H40-3 (TC) - H40-9 (GND) | W - W-B | TC terminal | When terminal TC is not connected | 8 to 14 V |
| H40-5 (IND) - H40-9 (GND) | LG - W-B | Tire pressure warning light output signal | After ignition switch is turned ON, when tire pressure warning light illuminates for 3 seconds | 2.2 to 4.4 V |
| Ignition switch ON Tire pressure warning light off | Below 0.5 V | |||
| H40-6 (RF5V) - H40-9 (GND) | Y - W-B | Tire pressure warning antenna and receiver power source | Ignition switch ON | 11 to 14 V |
| H40-7 (IG) - H40-9 (GND) | Y - W-B | IG power source | Ignition switch ON | 11 to 14 V |
| H40-9 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| H40-10 (SIL) - H40-9 (GND) | L - W-B | Diagnosis tester communication line | Ignition switch ON, when communication is not performed with a tester | 8 to 14 V |
| H40-11 (GND2) - H40-9 (GND) | P - W-B | Tire pressure warning antenna and receiver ground | Always | Below 1 Ω |
![]() |
Using an oscilloscope, check the waveform 1.
| Item | Content |
| Terminal No. (Symbol) | H40-2 (SPD) - H40-9 (GND) |
| Tool Setting | 5 V/DIV., 200 ms/DIV. |
| Vehicle Condition | While driving at approximately 20 km/h (12 mph). |