Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the audio system connected to the AVC-LAN (communication bus) transfers the signal of each switch by communication.
When a short to +B or short to ground occurs in this AVC-LAN, the audio system will not function normally as the communication is discontinued.

WIRING DIAGRAM


E189530E09


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER ASSEMBLY


    E145834E17
  1. Disconnect the I4*1 and I8*2 radio receiver assembly connectors.

    1. *1: for 14 Speakers
    2. *2: w/ USB Audio System

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I4-5 (ATX+) - I4-15 (ATX-)*1
    Always
    60 to 80 Ω
    I8-9 (TXM+) - I8-10 (TXM-)*2
    Always
    60 to 80 Ω

    1. *1: for 14 Speakers
    2. *2: w/ USB Audio System



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE)

HINT:
For details of the connectors, refer to "Terminals of ECU" (Click here).

  1. Referring to the wiring diagram, check the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.

    1. Disconnect all connectors between the radio receiver assembly and the component which has stored this code.

    2. Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)