Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT SWITCH

ROOM LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT INTERIOR DOME LIGHT SWITCH ASSEMBLY


    E146766E02
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      5 (FCTY) - 10 (FLMP)
      DOOR
      Below 1 Ω
      7 (E) - 10 (FLMP)
      ON
      Below 1 Ω

      If the result is not as specified, replace the interior dome light switch.

  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 1 (Ill+) and the negative (-) battery lead to terminal 4 (Ill-), and then check that the illumination illuminates.

      OK:
      Illumination illuminates.

      If the result is not as specified, replace the interior dome light switch.