Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Using the Techstream, inspect the CAN communication function to ensure there are no malfunctions in the communication system.
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B
      The skid control ECU sends the signals of each warning light to CAN communication.



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK DTC AND FREEZE FRAME DATA*

      NEXT


      5.CLEAR DTC AND FREEZE FRAME DATA*

        NEXT


        6.PROBLEM SYMPTOM CONFIRMATION

          NEXT


          7.DTC CHECK AND CLEAR*

            NEXT


            8.PROBLEM SYMPTOM CONFIRMATION
              Result 
              Result
              Proceed to
              Symptom does not occur
              A
              Symptom occurs
              B


            B.
            GO TO STEP 11
            A


            9.SYMPTOM SIMULATION

              NEXT


              10.CHECK FOR DTC (OTHER THAN CAN COMMUNICATION SYSTEM DTC)*
                Result 
                Result
                Proceed to
                DTC is not output
                A
                DTC is output
                B


              B.
              GO TO STEP 12
              A


              11.PROBLEM SYMPTOMS TABLE

                NEXT

                GO TO STEP 14


                12.DTC CHART

                  NEXT


                  13.CIRCUIT INSPECTION*

                    NEXT


                    14.IDENTIFICATION OF PROBLEM

                      NEXT


                      15.REPAIR OR REPLACE

                        NEXT


                        16.CONFIRMATION TEST*

                          NEXT

                          END