PARKING BRAKE PEDAL > REMOVAL |
| 1. RELEASE PARKING BRAKE PEDAL |
| 2. REMOVE FRONT DOOR SCUFF PLATE LH |
| 3. REMOVE COWL SIDE TRIM BOARD LH |
| 4. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, detach the 7 claws and remove the side panel.
| 5. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Disengage the 3 claws.
Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.
| 6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the 2 bolts.
Detach the 9 clips and claw.
![]() |
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
![]() |
Remove the 4 bolts and remove the instrument panel airbag.
Detach the 2 claws and disconnect the DLC3.
Disconnect the connector.
| 8. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Remove the lock nut and adjustment nut.
![]() |
Remove the clip.
![]() |
Using a screwdriver, slowly bend up the claw.
Disconnect the parking brake cable from the parking brake control pedal.
| 9. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY |
![]() |
Disconnect the connector.
Detach the wire harness clamp from the control pedal.
![]() |
Remove the 3 nuts and parking brake control pedal from the body.