PARKING BRAKE ASSEMBLY > INSPECTION |
| 1. CHECK BRAKE DISC INSIDE DIAMETER |
![]() |
Using a drum gauge or equivalent, measure the inside diameter of the disc.
| 2. CHECK PARKING BRAKE SHOE LINING THICKNESS |
![]() |
Using a ruler, measure the thickness of the shoe lining.
| 3. CHECK BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT |
![]() |
Apply chalk to the inside surface of the disc. Rub the brake shoe lining against the disc and check that full contact is achieved between the brake shoe and disc (chalk is transferred to the entire brake shoe lining).
If the disc and brake shoe lining do not have full contact, grind the brake shoe using a brake shoe grinder or replace the brake shoe.
After the inspection, wipe the chalk off of the inside surface of the disc and the lining surface.