DTC P0550 Power Steering Pressure Sensor Circuit Malfunction |
DTC P0552 Power Steering Pressure Sensor Circuit Low Input |
DTC P0553 Power Steering Pressure Sensor Circuit High Input |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0550 | Power steering oil pressure sensor voltage less than 0.28 V, or more than 4.9 V for 0.5 seconds while engine running. (1 trip detection logic) |
|
| P0552 | Power steering oil pressure sensor voltage less than 0.28 V for 0.5 seconds while engine running. (1 trip detection logic) |
|
| P0553 | Power steering oil pressure sensor voltage more than 4.9 V for 0.5 seconds while engine running. (1 trip detection logic) |
|

| Related DTCs | P0550: Power steering pressure sensor range check (Chattering) P0552: Power steering pressure sensor range check (Low Resistance) P0553: Power steering pressure sensor range check (High Resistance) |
| Required sensors/Components (Main) | Power steering pressure sensor |
| Frequency of operation | Continuous |
| Duration | 0.5 seconds |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not stored | None |
| Time after starter signal ON to OFF | 2 seconds or more |
| Power steering pressure sensor voltage | Less than 0.28 V, or more than 4.9 V |
| Power steering pressure sensor voltage | Less than 0.28 V |
| Power steering pressure sensor voltage | More than 4.9 V |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK HARNESS AND CONNECTOR (ECM - POWER STEERING OIL PRESSURE SENSOR) |
![]() |
Disconnect the D56 ECM connector.
Disconnect the D30 power steering oil pressure sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D30-2 (PSP) - D56-72 (PSP) | Always | Below 1 Ω |
| D30-1 (VC) - D56-67 (VCV1) | Always | Below 1 Ω |
| D30-3 (E2) - D56-97 (ETHW) | Always | Below 1 Ω |
| D30-2 (PSP) or D56-72 (PSP) - Body ground | Always | 10 kΩ or higher |
| D30-1 (VC) or D56-67 (VCV1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.REPLACE POWER STEERING OIL PRESSURE SENSOR |
Replace the power steering oil pressure sensor.
| NEXT | |
| 3.CONFIRM WHETHER DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| P0550, P0552 and/or P0553 are output | A |
| No DTC is output | B |
|
| ||||
| A | ||
| ||