Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE

FRONT BRAKE FLEXIBLE HOSE > INSTALLATION

for Preparation Click here



1. INSTALL FRONT FLEXIBLE HOSE


    C242482E01
  1. Attach 2 new clips (labeled A) to the flexible hose.

  1. Using a union nut wrench, connect the flexible hose to the brake tube and wheel cylinder tube while holding the flexible hose with a wrench.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



2. BLEED BRAKE LINE
  1. Bleed brake line

    1. Remove the brake master cylinder reservoir filler cap assembly.

    2. Add brake fluid into the reservoir between MAX and MIN level on the brake fluid reservoir.

      Brake fluid:
      SAE J1703 or FMVSS No. 116 DOT3

    3. Depress the brake pedal several times and loosen the bleeder plug. With the brake pedal depressed, bleed fluid from the front disc brake caliper RH and LH.

    4. After bleeding the fluid, tighten the bleeder plug and release the brake pedal.

      Torque:
      11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    5. Depress the brake pedal several times and loosen the bleeder plug. With the brake pedal depressed, bleed fluid from the rear disc brake caliper RH and LH.

    6. After bleeding the fluid, tighten the bleeder plug and release the brake pedal.

      Torque:
      11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Check and bleed brake system.

    1. If the following malfunction symptoms occur, air may have entered the brake fluid line. Perform the following air bleed procedures.

      1. Low pedal or spongy pedal.
      2. Brake pedal is depressed firmly but braking is insufficient.

  1. Check and adjust brake fluid level in reservoir (Click here).



3. INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
for Steel Wheel:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }