Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE

REAR BRAKE FLEXIBLE HOSE > INSTALLATION

for Preparation Click here



1. INSTALL REAR BRAKE TUBE FLEXIBLE HOSE


    C208574
  1. Install the flexible hose with the 2 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



    C208573
  1. Connect the flexible hose bracket with the bolt.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }



    C180573
  1. Install the flexible hose and a new gasket to the disc brake cylinder with a new union bolt.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    HINT:
    Install the flexible hose lock securely in the lock hole in the cylinder.



    C178154
  1. Set the flexible hose to the connecting point with the brake tube, and then attach a new clip.

  1. Using a union nut wrench, connect the flexible hose tube.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



2. BLEED BRAKE LINE
  1. Bleed brake line

    1. Remove the brake master cylinder reservoir filler cap assembly.

    2. Add brake fluid into the reservoir between MAX and MIN level on the brake fluid reservoir.

      Brake fluid:
      SAE J1703 or FMVSS No. 116 DOT3

    3. Depress the brake pedal several times and loosen the bleeder plug. With the brake pedal depressed, bleed fluid from the front disc brake caliper RH and LH.

    4. After bleeding the fluid, tighten the bleeder plug and release the brake pedal.

      Torque:
      11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    5. Depress the brake pedal several times and loosen the bleeder plug. With the brake pedal depressed, bleed fluid from the rear disc brake caliper RH and LH.

    6. After bleeding the fluid, tighten the bleeder plug and release the brake pedal.

      Torque:
      11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Check and bleed brake system.

    1. If the following malfunction symptoms occur, air may have entered the brake fluid line. Perform the following air bleed procedures.

      1. Low pedal or spongy pedal.
      2. Brake pedal is depressed firmly but braking is insufficient.

  1. Check and adjust brake fluid level in reservoir (Click here).



3. INSTALL REAR WHEEL

Torque:
for Aluminum Wheel:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
for Steel Wheel:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }