POWER STEERING SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT DRIVE BELT |
Visually check the belt for excessive wear, frayed cords, etc.
If any defect is found, replace the drive belt.
| 2. BLEED POWER STEERING SYSTEM |
Check the fluid level.
Jack up the front of the vehicle and support it with stands.
Turn the steering wheel.
With the engine stopped, turn the wheel slowly from lock to lock several times.
Lower the vehicle.
Start the engine.
Run the engine at idle for a few minutes.
Turn the steering wheel.
With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds.(*1)
Repeat (*1) several times.
Stop the engine.
![]() |
Check for foaming or emulsification.
| *a | Correct |
| *b | Incorrect |
Check the fluid level.
| 3. CHECK FLUID LEVEL |
![]() |
Keep the vehicle horizontal.
| *a | COLD range |
| *b | HOT range |
With the engine stopped, check the fluid level in the reservoir.
If necessary, add fluid.
Start the engine and run it at idle.
Turn the steering wheel from lock to lock several times to raise fluid temperature.
![]() |
Check for foaming or emulsification.
| *a | Correct |
| *b | Incorrect |
![]() |
With the engine idling, measure the fluid level in the reservoir.
| *a | Engine idling |
| *b | Engine stopped |
| *c | 5.0 mm (0.197 in.) or less |
Stop the engine.
Wait a few minutes and remeasure the fluid level in the reservoir.
Check the fluid level.
| 4. CHECK STEERING FLUID PRESSURE |
Disconnect the pressure feed tube from the vane pump.
for 1UR-FE, refer to the following procedures .
for 3UR-FE and 3UR-FBE, refer to the following procedures .
Connect SST as shown in the illustration.
Bleed the power steering system.
Start the engine and run it at idle.
Turn the steering wheel from lock to lock several times to raise fluid temperature.

| *1 | Attachment | *2 | Pressure Feed Tube |
| *a | IN | *b | OUT |
![]() |
With the engine idling, close the valve of SST and observe the reading on SST.
| *1 | Power Steering Gear Assembly |
| *2 | Vane Pump Oil Reservoir Assembly |
| *3 | Vane Pump Assembly |
| *a | Valve Closed |
With the engine idling, fully open the valve.
![]() |
Measure the fluid pressure at engine speeds of 1000 rpm and 3000 rpm.
| *1 | Power Steering Gear Assembly |
| *2 | Vane Pump Oil Reservoir Assembly |
| *3 | Vane Pump Assembly |
| *a | Valve Open |
![]() |
With the engine idling and the valve fully open, turn the steering wheel left or right to the full lock position. Observe the reading on SST.
| *1 | Power Steering Gear Assembly (Lock Position) |
| *2 | Vane Pump Oil Reservoir Assembly |
| *3 | Vane Pump Assembly |
| *a | Valve Open |
Disconnect SST.
Connect the pressure feed tube for 1UR-FE .
Connect the pressure feed tube for 3UR-FE and 3UR-FBE .
Bleed the power steering system.