SOLAR SENSOR > INSPECTION |
| 1. INSPECT SOLAR SENSOR (AUTOMATIC LIGHT CONTROL SENSOR) |
![]() |
Remove the solar sensor with the connector still connected.
Apply battery voltage between terminals 6 (CLTB) and 3 (CLTE) of the A/C solar sensor.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (TSL) - 3 (CLTE) | Sensor subject to electric light | 0.8 to 4.3 V |
| 1 (TSL) - 3 (CLTE) | Sensor covered with a cloth | Below 0.8 V |
| 2 (TSR) - 3 (CLTE) | Sensor subject to electric light | 0.8 to 4.3 V |
| 2 (TSR) - 3 (CLTE) | Sensor covered with a cloth | Below 0.8 V |