VEHICLE STABILITY CONTROL SYSTEM > CALIBRATION |
| DESCRIPTION |
| Replacing Part/Operation | Necessary Operation |
| VSC actuator (Skid Control ECU) |
|
| Yaw Rate Sensor |
|
| Front Wheel Alignment Adjustment |
|
| CLEAR ZERO POINT CALIBRATION DATA (WHEN USING TECHSTREAM) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select the skid control ECU to clear the zero point calibration date using the Techstream.
Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Reset Memory.
| PERFORM ZERO POINT CALIBRATION OF MASTER CYLINDER PRESSURE SENSOR AND DECELERATION SENSOR (WHEN USING TECHSTREAM) |
Enter Test Mode.
Turn the ignition switch off.
Check that the shift lever is in P or N and apply the parking brake.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Test Mode.
Obtain the zero points of the master cylinder pressure sensor and deceleration sensor.
Keep the vehicle stationary on a level surface for 1 second or more.
Check that DTC C1336 is cleared.
Turn the ignition switch off.
| CLEAR ZERO POINT CALIBRATION DATA (WHEN USING SST CHECK WIRE) |
Turn the ignition switch to ON.
![]() |
Using SST, connect and disconnect terminals 12 (TS) and 4 (CG) of the DLC3 4 times or more within 8 seconds.
Check that the slip indicator light comes on.
Using a check wire, perform the zero point calibration of the deceleration sensor.
| PERFORM ZERO POINT CALIBRATION OF MASTER CYLINDER PRESSURE SENSOR AND DECELERATION SENSOR (WHEN USING SST CHECK WIRE) |
Enter Test Mode.
Turn the ignition switch off.
Check that the shift lever is in P or N and apply the parking brake.
![]() |
Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.
Turn the ignition switch to ON.
Obtain the zero points of the master cylinder pressure sensor and deceleration sensor.
Keep the vehicle stationary on a level surface for 1 second or more.
Check that DTC C1336 is cleared.
Turn the ignition switch off.
| PERFORM INITIALIZATION OF STEERING ANGLE SENSOR |
Check that the steering wheel is in the centered position.
Disconnect the negative battery terminal for more than 2 seconds.
Reconnect the negative battery terminal.