AIR SUSPENSION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
| |||||
| 4.CHECK AND CLEAR DTC* |
Check if any DTCs are output (Click here).
| Result | Proceed to |
| CAN DTC not output | A |
| CAN DTC output | B |
|
| ||||
| |||||
| 5.CHECK AND CLEAR DTC* |
Check for a DTC (Click here).
| |||||
| 6.PROBLEM SYMPTOM CONFIRMATION |
Measure the resistance according to the value(s) in the table below.
| Result | Proceed to |
| Symptom Does Not Occur | A |
| Symptom Occurs | B |
|
| ||||
| |||||
| 7.SYMPTOM SIMULATION |
| |||||
| 8.CHECK DTC* |
Check for a DTC (Click here).
| Result | Proceed to |
| DTC not output | A |
| DTC output | B |
|
| ||||
| |||||
| 9.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
| |||||
| 10.DTC CHART |
Refer to the Diagnostic Trouble Code Chart (Click here).
| |||||
| 11.CIRCUIT INSPECTION* |
Inspect the circuit.
| |||||
| 12.IDENTIFICATION OF PROBLEM |
| |||||
| 13.REPAIR OR REPLACE |
| |||||
| 14.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|