Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH


B190151
  1. Detach the 9 claws and remove the scuff plate.



2. REMOVE COWL SIDE TRIM BOARD RH


B190152
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim board.



3. REMOVE INSTRUMENT SIDE PANEL RH


    B229197
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B226758
  1. Detach the clip and 4 claws.

  1. Detach the 2 guides and remove the under cover.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B226741
  1. Remove the bolt <A> and 3 <D> screws.

  1. Detach the 3 claws and remove the finish panel.



    B230430
  1. Disconnect the connector.



6. REMOVE TIRE PRESSURE WARNING ECU
  1. Disconnect the tire pressure warning ECU connector.



    C178149
  1. Remove the 2 nuts and the tire pressure warning ECU.