Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using a Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus:
    Select: Body Electrical / Main Body or Back Door ECU / Data List /

  5. According to the display on the Techstream, read the Data List.

    Main Body (Main Body ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Unlock Warning SW
    Unlock warning switch signal / ON or OFF
    ON: Key is inserted in the ignition key cylinder
    OFF: Key is removed from the ignition key cylinder
    -
    ACC SW
    Ignition switch ACC signal / ON or OFF
    ON: Ignition switch is ACC
    OFF: Ignition switch is off
    -
    IG SW
    Ignition switch signal / ON or OFF
    ON: Ignition switch is ON
    OFF: Ignition switch is off
    -
    D Door Courtesy SW
    D door courtesy switch / ON or OFF
    ON: Driver side door is OPEN
    OFF: Driver side door is CLOSED
    -
    P Door Courtesy SW
    P door courtesy switch / ON or OFF
    ON: Front passenger side door is OPEN
    OFF: Front passenger side door is CLOSED
    -
    RR Door Courtesy SW
    Rear right door courtesy switch / ON or OFF
    ON: Rear right door is OPEN
    OFF: Rear right door is CLOSED
    -
    RL Door Courtesy SW
    Rear left door courtesy switch / ON or OFF
    ON: Rear left door is OPEN
    OFF: Rear left door is CLOSED
    -
    D-Door Lock Pos SW
    Driver's door lock position switch / ON or OFF
    ON: Driver's door is UNLOCKED
    OFF: Driver's door is LOCKED
    -
    P-Door Lock Pos SW
    Passenger door lock position switch / ON or OFF
    ON: Passenger door is UNLOCKED
    OFF: Passenger door is LOCKED
    -
    RR-Door Lock Pos SW
    Rear right door lock position switch / ON or OFF
    ON: Rear right door is UNLOCKED
    OFF: Rear right door is LOCKED
    -
    RL-Door Lock Pos SW
    Rear left door lock position switch / ON or OFF
    ON: Rear left door is UNLOCKED
    OFF: Rear left door is LOCKED
    -
    Hood Courtesy Switch
    Engine hood courtesy signal / ON or OFF
    ON: Engine hood is OPEN
    OFF: Engine hood is CLOSED
    -
    Glass Break Sensor Detection*
    Glass breakage sensor detection /
    ON or OFF
    ON: Glass breakage sensor is ON
    OFF: Glass breakage sensor is off
    -
    Passive Mode
    Passive mode / ON or OFF
    ON: Passive mode is ON
    OFF: Passive mode is off
    -
    Warning by Horn
    Warning by horn / ON or OFF
    ON: Vehicle horns sound during alarm sounding state
    OFF: Vehicle horns do no sound during alarm sounding state
    -
    Glass Breakage Sensor*
    Glass breakage sensor / ON or OFF
    ON: Glass breakage sensor is ON
    OFF: Glass breakage sensor is off
    -
    Entry Delay
    Entry delay time during passive mode
    0 s: Entry delay time is 0 sec.
    14 s: Entry delay time is 14 sec.
    30 s: Entry delay time is 30 sec.
    -

    HINT:
    *: w/ Glass Breakage Sensor


    Back Door ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Back Door Courtesy SW
    Back door courtesy switch / ON or OFF
    ON: Back door is OPEN
    OFF: Back door is CLOSED
    -


ACTIVE TEST

HINT:
Using a Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus:
    Select: Body Electrical / Main Body / Active Test /

  5. According to the display on the Techstream, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Hazard
    Hazard warning lights
    ON/OFF
    -
    Vehicle Horn
    Vehicle horns
    ON/OFF
    -
    Security Indicator
    Security indicator
    ON/OFF
    -
    Security Horn
    Security horn
    ON/OFF
    -