Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Horn Circuit

for Preparation Click here


DESCRIPTION

When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU transmits a signal to cause the horn to sound at intervals of 0.4 seconds.

WIRING DIAGRAM


B191886E01


INSPECTION PROCEDURE

1.INSPECT HORNS
  1. Press the horn switch and check if the horns sound.
    Result 
    Result
    Proceed to
    Horns sound
    A
    Horns do not sound
    B



B
GO TO HORN SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect a Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn a Techstream main switch on.

  1. Select the item below in the Active Test and then check that the horns operate.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Vehicle Horn
    Vehicle horns
    ON/OFF
    -

    OK:
    The vehicle horns sound or stop correctly when operating them through the Techstream.



NG
Go to step 3
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE ROOM JUNCTION BLOCK)


  1. Disconnect the DB main body ECU connector.


    B191890E01

  1. Remove the integration relay from the engine room junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    DB-1 - 1A-7
    Always
    Below 1 Ω
    DB-1 or 1A-7 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU