Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER


    E146471E01
  1. Install the ultrasonic sensor retainer to the rear bumper.

    NOTICE:
    Do not damage the bumper with the snap when installing the retainer.

    HINT:
    When installing the retainer, align the keyhole and snap as shown in the illustration.



2. INSTALL NO. 1 ULTRASONIC SENSOR


    E146472
  1. Engage the 2 claws and install the ultrasonic sensor.

  1. Connect the sensor connector.



3. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER


    E146473E01
  1. Install the ultrasonic sensor retainer to the rear bumper.

    NOTICE:
    Do not damage the bumper with the snap when installing the retainer.

    HINT:
    When installing the retainer, align the keyhole and snap as shown in the illustration.



4. INSTALL NO. 2 ULTRASONIC SENSOR


    E146466
  1. Engage the 2 claws and install the ultrasonic sensor.

  1. Connect the connector.



5. INSTALL REAR BUMPER COVER


B191656
  1. Engage the 12 claws and install the rear bumper cover.



    B195443
  1. Engage the 2 harness clamps and connect the connector.



    B191655E02
  1. Tighten the 6 bolts for upper side of the rear bumper cover.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Tighten the 2 bolts for lower side of the rear bumper cover.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Tighten the 2 screws and install the 2 clips.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. INSTALL REAR QUARTER PANEL MUDGUARD LH


B191653
  1. Install the rear quarter panel mudguard with the clip.

  1. Tighten the 9 screws.



7. INSTALL REAR QUARTER PANEL MUDGUARD RH

HINT:
Use the same procedure as for the LH side.