Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Front Side)

ULTRASONIC SENSOR (for Front Side) > REMOVAL

for Preparation Click here



1. REMOVE FRONT END PANEL LH (w/o Headlight Cleaner System)


    B191650
  1. Remove the 2 clips.



    B191651
  1. Disengage the 2 clips and remove the front end panel.



2. REMOVE FRONT END PANEL RH (w/o Headlight Cleaner System)

HINT:
Use the same procedure as for the LH side.



3. REMOVE FRONT END PANEL LH (w/ Headlight Cleaner System)


    B191650
  1. Remove the 2 clips.



    B191652
  1. Disengage the 2 claws and 2 clips and remove the front end panel.



4. REMOVE FRONT END PANEL RH (w/ Headlight Cleaner System)

HINT:
Use the same procedure as for the LH side.



5. REMOVE FRONT BUMPER COVER


    B195056E01
  1. Apply protective tape as shown in the illustration.



    B194112E01
  1. Using a screwdriver, turn each pin hold clip 90° remove the 2 pin hold clips.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a clip remover, remove the clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B194113
  1. Remove the 8 clips.

  1. Remove the 7 screws.



    B194114
  1. Detach the 4 claws and remove the front bumper cover.

  1. Disconnect the connectors.

    HINT:
    This procedure is only necessary for vehicles equipped with fog lights or the intuitive parking assist system.



6. REMOVE NO. 1 ULTRASONIC SENSOR
  1. Disconnect the connector.



    E134853
  1. While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.

    HINT:
    The type of the claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting to removing the sensor.



7. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    E146464
  1. Disengage the 2 claws and remove the ultrasonic sensor retainer from the front bumper.