Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)

FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) > Front Power Seat does not Operate with Front Power Seat Switch

for Preparation Click here


DESCRIPTION

When a signal is input into the position control ECU, the ECU manages the signals received from the front power seat switch LH, and operates each motor. When 2 or more signals are input, the motors only operate when the signals are from the slide switch and reclining switch.

WIRING DIAGRAM


B188605E02


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B1, ECU-IG No. 1, FR P/SEAT LH)


    B188606E01
  1. Remove the ECU-B1 fuse from the engine room relay block.

  1. Remove the ECU-IG No. 1 and FR P/SEAT LH fuses from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-B1 fuse
    Always
    Below 1 Ω
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω
    FR P/SEAT LH fuse
    Always
    Below 1 Ω



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH LH - BATTERY AND BODY GROUND)


    B188607E01
  1. Disconnect the X10 and X11 switch connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    X10-5 (+B) - Body ground
    Always
    11 to 14 V
    X11-4 (IG) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    X11-8 (SYSB) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    X10-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FRONT POWER SEAT SWITCH LH (Click here)