DTC B2784 Antenna Coil Open / Short |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2784 |
|
|

| 1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER) |
![]() |
Disconnect the H32 ECU connector.
Disconnect the H27 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H32-14 (VC5) - H27-1 (VC5) | Always | Below 1 Ω |
| H32-15 (CODE) - H27-4 (CODE) | ||
| H32-4 (TXCT) - H27-5 (TXCT) | ||
| H32-5 (AGND) - H27-7 (AGND) | ||
| H32-14 (VC5) or H27-1 (VC5) - Body ground | Always | 10 kΩ or higher |
| H32-15 (CODE) or H27-4 (CODE) - Body ground | ||
| H32-4 (TXCT) or H27-5 (TXCT) - Body ground | ||
| H32-5 (AGND) or H27-7 (AGND) - Body ground |
Reconnect the ECU connector.
Reconnect the amplifier connector.
|
| ||||
| OK | |
| 2.INSPECT TRANSPONDER KEY ECU (VC5,AGND) |
![]() |
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H32-14 (VC5) - Body ground | No key is in ignition key cylinder | Below 1 V |
| H32-14 (VC5) - Body ground | Key is in ignition key cylinder | 4.6 to 5.4 V |
| Tester Connection | Condition | Specified Condition |
| H32-5 (AGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.REPLACE TRANSPONDER KEY AMPLIFIER |
Temporarily replace the transponder key amplifier with a new or normally functioning one (Click here).
| NEXT | |
| 4.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 5.CHECK FOR DTC |
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||