SUSPENSION CONTROL SYSTEM > PRECAUTION |
| 1.WHEN LIFTING VEHICLE |
![]() |
When jacking up or lifting the vehicle , stop operation of the air suspension control system by pressing the height control mode select switch.
| 2.DISCONNECTION AND CONNECTION OF HEIGHT CONTROL TUBE (TYPE1) |
![]() |
Disconnect the height control tube.
Pinch section "A" of the connector No. 1 and pull it from the housing.
![]() |
Set the SST to the tube.
![]() |
Insert SST into the housing to expand the claw of the connector No. 2 in the housing.
Pull out the tube with SST inserted.
Insert a screwdriver into the circular hole on the housing, and remove the connector No. 2, the 2 O-rings and the plate from the housing.
![]() |
Install 2 O-rings and the plate.
Apply MP grease to 2 new O-rings and the plate and install them to the straight tube or an equivalent.
![]() |
Insert the tube on which the 2 O-rings and plate are installed into the housing, and then push it in lightly with a piece of rolled up cardboard.
![]() |
Push the connector No. 2 into the housing to where a clicking sound is heard.
![]() |
Install the height control tube.
Push the tube and connector No. 1 into the housing to where a clicking sound is heard.
| 3.DISCONNECTION AND CONNECTION OF HEIGHT CONTROL TUBE (TYPE2) |
![]() |
Disconnect the height control tube.
Remove the holder.
![]() |
Spread the clip and slowly pull the height control tube straight out.
Remove the 2 O-rings.
![]() |
Install the height control tube.
If replacing the clip: Hook one side of the new clip around the union groove, and slide the other side into the opposite side of the union groove.
If not replacing the clip: Install 2 new O-rings to the height control tube and coat them with MP grease No. 2.
Securely connect the height control tube straight onto the connector until a clicking sound is heard.
Install the height control tube to the holder, being careful not to apply excessive force to the clip.