Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › SKID CONTROL BUZZER

SKID CONTROL BUZZER > INSTALLATION

for Preparation Click here



1. INSTALL SKID CONTROL BUZZER ASSEMBLY


    C154454
  1. Connect the buzzer connector.

    NOTICE:
    Securely connect the connector.

  1. Attach the clamp to install the buzzer.

    NOTICE:
    1. Securely insert the clamp into the bracket of the instrument panel reinforcement.
    2. If the buzzer is dropped, replace it.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Attach the 2 claws to install the sensor.

  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.

  1. engage the 3 claws to install the hood lock lever



4. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



5. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



6. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.