AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - STEREO JACK ADAPTER) |
![]() |
Disconnect the H114 multi-media interface ECU connector.
Disconnect the H107 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H114-2 (UDI+) - H107-2 (UDO-) | Always | Below 1 Ω |
| H114-3 (UDI-) - H107-3 (UDO+) | Always | Below 1 Ω |
| H114-2 (UDI+) - Body ground | Always | 10 kΩ or higher |
| H114-3 (UDI-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||