Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends an external device sound signal to the radio receiver assembly through this circuit.
The sound signal that has been sent is amplified by the radio receiver assembly and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly or speakers.

WIRING DIAGRAM


E192954E02


E192955E07


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER)


    E145924E06
  1. w/o USB Audio System:

    1. Disconnect the I3 radio receiver assembly connector.

    2. Disconnect the H7 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      I3-17 (ALI) - H7-1 (ALO)
      Always
      Below 1 Ω
      I3-15 (ARI) - H7-2 (ARO)
      Always
      Below 1 Ω
      I3-16 (ASGN) - H7-3 (ASGN)
      Always
      Below 1 Ω
      I3-18 (AUXG) - H7-5 (AUXG)
      Always
      Below 1 Ω
      I3-19 (AUXI) - H7-4 (AUXO)
      Always
      Below 1 Ω
      I3-17 (ALI) - Body ground
      Always
      10 kΩ or higher
      I3-15 (ARI) - Body ground
      Always
      10 kΩ or higher
      I3-16 (ASGN) - Body ground
      Always
      10 kΩ or higher
      I3-19 (AUXI) - Body ground
      Always
      10 kΩ or higher



    E192953E03
  1. w/ USB Audio System:

    1. Disconnect the I3 radio receiver assembly connector.

    2. Disconnect the H107 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      I3-17 (ALI) - H107-6 (ALO)
      Always
      Below 1 Ω
      I3-15 (ARI) - H107-5 (ARO)
      Always
      Below 1 Ω
      I3-16 (ASGN) - H107-7 (ASGN)
      Always
      Below 1 Ω
      I3-18 (AUXG) - H107-9 (AGND)
      Always
      Below 1 Ω
      I3-19 (AUXI) - H107-8 (AUXO)
      Always
      Below 1 Ω
      I3-17 (ALI) - Body ground
      Always
      10 kΩ or higher
      I3-15 (ARI) - Body ground
      Always
      10 kΩ or higher
      I3-16 (ASGN) - Body ground
      Always
      10 kΩ or higher
      I3-19 (AUXI) - Body ground
      Always
      10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)