Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR

AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT AIR CONDITIONER PRESSURE SENSOR


    E161562E02
  1. Install the manifold gauge set.

  1. Disconnect the connector from the air conditioner pressure sensor.

  1. Connect the three 1.5 V dry cell batteries' positive (+) lead to terminal 3 and the negative (-) lead to terminal 1.

  1. Connect the voltmeter's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Refrigerant pressure:
    0.39 to 3.187 MPa (4 to 32.5 kgf/cm2, 57 to 463 psi)
    1.0 to 4.8 V

    If the result is not as specified, replace the air conditioning pressure sensor.