NAVIGATION SYSTEM (for DVD) > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the I20 navigation receiver assembly connector.
Disconnect the I17 stereo component amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I20-8 (R+) - I17-5 (R+) | Always | Below 1 Ω |
| I20-18 (R-) - I17-4 (R-) | Always | Below 1 Ω |
| I20-9 (L+) - I17-3 (L+) | Always | Below 1 Ω |
| I20-19 (L-) - I17-2 (L-) | Always | Below 1 Ω |
| I20-10 (SLD) - I17-6 (SLD) | Always | Below 1 Ω |
| I20-10 (SLD) - Body ground | Always | 10 kΩ or higher |
| I20-8 (R+) - Body ground | Always | 10 kΩ or higher |
| I20-18 (R-) - Body ground | Always | 10 kΩ or higher |
| I20-9 (L+) - Body ground | Always | 10 kΩ or higher |
| I20-19 (L-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||