Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Multi-media Interface ECU and Television Display Assembly

for Preparation Click here


DESCRIPTION

The multi-media interface ECU sends sound signals to the television display assembly through this circuit. If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly, stereo component amplifier assembly or speakers.

WIRING DIAGRAM


E190432E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - TELEVISION DISPLAY)


    E190380E01
  1. Disconnect the H111 multi-media interface ECU connector.

  1. Disconnect the U2 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H111-7 (ULI+) - U2-30 (L+)
    Always
    Below 1 Ω
    H111-15 (ULI-) - U2-31 (L-)
    Always
    Below 1 Ω
    H111-8 (URI+) - U2-28 (R+)
    Always
    Below 1 Ω
    H111-16 (URI-) - U2-29 (R-)
    Always
    Below 1 Ω
    H111-7 (ULI+) - Body ground
    Always
    10 kΩ or higher
    H111-15 (ULI-) - Body ground
    Always
    10 kΩ or higher
    H111-8 (URI+) - Body ground
    Always
    10 kΩ or higher
    H111-16 (URI-) - Body ground
    Always
    10 kΩ or higher
    U2-27 (SLD9) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)