NAVIGATION SYSTEM (for DVD) > Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION DISPLAY) |
![]() |
Disconnect the I35 navigation receiver assembly connector.
Disconnect the U2 television display assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I35-2 (VV+) - U2-11 (NTSC) | Always | Below 1 Ω |
| I35-6 (VV-) - U2-10 (SGN1) | Always | Below 1 Ω |
| I35-2 (VV+) - Body ground | Always | 10 kΩ or higher |
| I35-6 (VV-) - Body ground | Always | 10 kΩ or higher |
| U2-9 (SLD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK TELEVISION DISPLAY ASSEMBLY |
![]() |
Reconnect the U2 television display assembly connector.
Measure the waveform according to the table below.
| Tester Connection | Condition | Specified Condition |
| U2-11 (NTSC) - Body ground | DVD display is on | A waveform synchronized with display signals is output |
![]() |
Using an oscilloscope, check waveform.
| Item | Content |
| Terminal No. (Symbol) | U2-11 (NTSC) - Body ground |
| Tool Setting | 0.2 V/DIV., 50 μsec./DIV. |
| Condition | DVD display is ON |
|
| ||||
| OK | ||
| ||