Home › Vehicle Interior › HEATING / AIR CONDITIONING › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT MAGNET CLUTCH RELAY


E190148E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      When battery voltage is not applied
      10 kΩ or higher
      3 - 5
      When battery voltage applied to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the relay.



2. INSPECT CONDENSER FAN RELAY


E190148E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      When battery voltage is not applied
      10 kΩ or higher
      3 - 5
      When battery voltage applied to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the relay.