Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Rear Door)

BLACK OUT TAPE (for Rear Door) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 BLACK OUT TAPE
  1. Application precautions .

  1. Clean the attachment surface (using an infrared light) .

  1. Clean the attachment surface (using a tape removal disc) .



  1. Apply new No. 2 black out tape to the positions shown in the illustration.


    B191715E01

    Installation Position:
    Mark
    Measurement
    a
    2.0 mm (0.079 in.)
    b
    3.0 mm (0.118 in.)
    c
    1.0 or less (0.039 or less in.)



2. INSTALL REAR DOOR GLASS RUN

HINT:
Use the same procedure as for the RH side .



3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



4. INSTALL REAR DOOR ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the RH side .



5. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

HINT:
Use the same procedure as for the RH side .



6. INSTALL REAR DOOR FRAME GARNISH

HINT:
Use the same procedure as for the RH side .



7. INSTALL REAR DOOR GLASS OUTER WEATHERSTRIP


B191705
  1. Engage the 5 claws and clip and install a new rear door glass outer weatherstrip.



8. INSTALL REAR DOOR WINDOW FRAME REAR MOULDING

HINT:
When installing the rear door window frame rear moulding, heat the vehicle body and rear door window frame rear moulding using a heat light.

Standard:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Rear Door Window Frame Rear Moulding
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or rear door window frame rear moulding excessively.

  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove the double-sided tape from the vehicle body surface.

    3. Wipe off any tape adhesive residue with cleaner.



    B256636E01
  1. Install a new rear door window frame rear moulding.

    1. Using a heat light, heat a new rear door window frame rear moulding and the vehicle body surface.

    2. Remove the peeling paper from the face of the rear door window frame rear moulding.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    3. Attach the 2 clips and double-sided tape to install the rear door window frame rear moulding.

      HINT:
      When installing the rear door window frame rear moulding, be sure to press the area attached with the double-sided tape with sufficient force {30 N (3 kgf, 6.7 lbf) or more}.