POWER STEERING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Confirm problem symptoms (Click here).
| |||||
| 3.INSPECT BATTERY VOLTAGE* |
Measure the voltage of the battery.
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
| Result | Proceed to |
| Symptom does not occur | A |
| Symptom occurs | B |
|
| ||||
| |||||
| 5.SYMPTOM SIMULATION |
Perform symptom simulation (Click here).
| |||||
| 6.CHECK CAN COMMUNICATION SYSTEM* |
Check for DTCs (Click here).
| Result | Proceed to |
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
|
| ||||
| |||||
| 7.CHECK FOR DTC* |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 8.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| |||||
| 9.CIRCUIT INSPECTION |
| |||||
| 10.IDENTIFICATION OF PROBLEM |
| |||||
| 11.REPAIR OR REPLACE |
| |||||
| 12.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|