POWER STEERING SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / PPS / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Steering Angle Velocity | Steering angle speed/ Min.: -32768 deg/s Max.: 32767 deg/s | Value changes in proportion to steering effort | The engine is running and the steering wheel is being turned. |
| Meter Vehicle Velocity | Vehicle speed/ Min.: 0.00 km/h (0.00 mph) Max.: 300.00 km/h (186.41 mph) | 0 km/h (0 mph) | The vehicle is stopped. |
| No large fluctuation | The vehicle is driven at a constant speed. | ||
| Engine Revolution | Engine speed/ Min.: 0 rpm Max.: 12800 rpm | No large fluctuation | The engine is running at a constant speed. |
| Steering Angle | Steering angle/ Min.: -2048.0 deg Max.: 2047.0 deg | Left turn: Increases Right turn: Decreases | The engine is running and the steering wheel is being turned. |
| Solenoid Current | Solenoid Current/ Min.: 0 mA Max.: 1000 mA | 200 to 950 mA | The engine is running and the steering wheel is being turned. |
| IG Power Supply | ECU power source voltage/ Min.: 0.0 V Max.: 25.5 V | 11 to 14 V | The ignition switch is ON. |
| The Number of DTCs | Number of detected DTCs when freeze frame data stored/ Min.: 0, Max.: 255 | - | - |