Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Enter the following menus: Body Electrical / Main Body or Back Door P/W / Data List.

  4. Read the Data List according to the display on the Techstream.

    Main Body (Main Body ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Driver side door courtesy light switch signal / ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -
    P Door Courtesy SW
    Passenger side door courtesy light switch signal / ON or OFF
    ON: Passenger side door is open
    OFF: Passenger side door is closed
    -
    RR Door Courtesy SW
    Rear door RH courtesy light switch signal / ON or OFF
    ON: Rear door RH is open
    OFF: Rear door RH is closed
    -
    RL Door Courtesy SW
    Rear door LH courtesy light switch signal / ON or OFF
    ON: Rear door LH is open
    OFF: Driver side door is locked
    -
    D-Door Lock Pos SW
    Driver side door unlock detection switch signal / ON or OFF
    ON: Driver side door is unlocked
    OFF: Driver side door is locked
    -
    Key Unlock Warning SW
    Unlock warning switch / ON or OFF
    ON: Ignition key is inserted
    OFF: Ignition key is not inserted
    -

    Back Door P/W (Back Door ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Back Door Courtesy SW
    Back door courtesy switch signal / ON or OFF
    ON: Back door is open
    OFF: Back door is closed
    -


ACTIVE TEST

HINT:
Using the Techstream to perform Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing the Active Test early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Enter the following menus: Body Electrical / Main Body / Active Test.

  4. Perform the Active Test according to the display on the Techstream.

    Main Body (Main Body ECU) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Hazard
    Turns the turn signal flasher relay
    ON/OFF
    Observe headlight and rear combination light for correct operation
    Vehicle Horn
    Turns the vehicle horns
    ON/OFF
    -
    Illuminated Entry System
    Interior light and ignition key cylinder light (Interior light switch is in DOOR position and all doors are closed)
    ON/OFF
    -
    Trunk and Back-Door Open
    Turns the back door opener motor
    ON/OFF
    Observe back door
    Wireless Buzzer
    Wireless door lock buzzer
    ON/OFF
    -