Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Rear)

WASHER MOTOR (for Rear) > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


E161704E01

HINT:
This check should be performed with the windshield washer motor and pump installed to the washer jar.

  1. Fill the washer jar with washer fluid.

  1. Connect the positive (+) battery lead to terminal 1 of the windshield washer motor and pump, and the negative (-) battery lead to terminal 2. Check that washer fluid flows from the washer jar.

    OK:
    Washer fluid flows from washer jar.

    If the result is not as specified, replace the windshield washer motor and pump.