Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR CLOSER SYSTEM

BACK DOOR CLOSER SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Back Door or Back Door P/W / Data List /

  5. According to the display on the Techstream, read the Data List.

    Back Door (Power Back Door ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Door Lock Status
    Back door lock condition signal / LOCK or UNLOCK
    LOCK: Back door is locked
    UNLOCK: Back door is unlocked
    -
    Courtesy SW
    Back door courtesy switch signal / ON or OFF
    ON: Back door is open
    OFF: Back door is closed
    -
    Closer Position SW
    Closer position switch signal / ON or OFF
    ON: Back door lock center gear is in center position
    OFF: Back door lock center gear is not in center position
    -
    Half Latch SW
    Half-latch switch signal / ON or OFF
    ON: Back door lock motor is open-latch or over-latch
    OFF: Back door lock motor is full-latch or half-latch
    -

    Back Door P/W (Back Door ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Switch Operation Locked
    Back door key linked switch signal / ON or OFF
    ON: Back door key linked switch turned to lock position
    OFF: Back door key linked switch not turned
    -
    Key Switch Operation Unlocked
    Back door key linked switch signal / ON or OFF
    ON: Back door key linked switch turned to unlock position
    OFF: Back door key linked switch not turned
    -
    Back Door Courtesy SW
    Back door courtesy switch signal / ON or OFF
    ON: Back door is open
    OFF: Back door is closed
    -
    Back Door Handle Switch
    Back door opener switch signal / ON or OFF
    ON: Back door opener switch is ON
    OFF: Back door opener switch is OFF
    -


ACTIVE TEST

HINT:
Using the Techstream to perform Active Test allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Back Door / Active Test /

  5. According to the display on the Techstream, perform the Active Test.

    Back Door (Power Back Door ECU) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Latch Release
    Power back door motor
    ON/OFF
    -