Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for 2WD)

PROPELLER SHAFT ASSEMBLY (for 2WD) > INSPECTION

for Preparation Click here



1. INSPECT PROPELLER SHAFT ASSEMBLY


    C179285
  1. Using a dial indicator, check the propeller shaft runout.

    Maximum runout:
    1.02 mm (0.0402 in.)

    If the shaft runout is greater than the maximum, replace the shaft.



2. INSPECT UNIVERSAL J0INT SPIDER BEARING


    C134366
  1. Mount the propeller shaft in a vise.

  1. Inspect the spider bearing for wear or damage.

  1. Using a dial indicator, measure the spider bearing axial play by turning the yoke of the flange while holding the shaft tightly.

    Maximum bearing axial play:
    0.05 mm (0.00197 in.)

    If the spider bearing axial play exceeds the maximum, replace the spider bearing.