Home › Engine / Hybrid System · CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DYNAMIC LASER CRUISE CONTROL SYSTEM > Laser Sensor Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the laser radar sensor. The laser radar sensor emits radio waves towards an object in front and measures the distance and direction of the object by receiving the beam reflections. Based on the reflections, the sensor calculates the difference in speed between the vehicle and the object in front. This data is transmitted to the distance control ECU. The ECM recognizes the laser radar sensor via terminals LGND. If an open circuit occurs in the wire harness between terminals LGND, the ECM cannot recognize the laser radar sensor. The ECM will stop the control of the vehicle-to-vehicle distance control mode and only the constant speed control mode can be used.

WIRING DIAGRAM


E163058E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (IGB VOLTAGE)


    E163059E01
  1. Disconnect the A26 laser radar sensor connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A26-5 (IGB) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Reconnect the laser radar sensor connector.



NG
Go to step 3
OK


2.CHECK HARNESS AND CONNECTOR (LASER RADAR SENSOR - ECM AND BODY GROUND)


    E163085E01
  1. Disconnect the A27 connector from the ECM.

  1. Disconnect the A26 connector from the laser radar sensor.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-44 (LGND) - A26-1 (LGND)
    Always
    Below 1 Ω
    A26-1 (LGND) - Body ground
    Always
    10 kΩ or higher
    A26-2 (SGND) - Body ground
    Always
    Below 1 Ω

  1. Reconnect the ECM and laser radar sensor connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (LASER RADAR SENSOR - DISTANCE CONTROL ECU)


    I044456E19
  1. Disconnect the A43 distance control ECU connector.

  1. Disconnect the A26 laser radar sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A26-5 (IGB) - A43-13 (IGB)
    Always
    Below 1 Ω
    A43-13 (IGB) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the ECU and laser radar sensor connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DISTANCE CONTROL ECU (Click here)